Niko configuration software for access control
Using Niko configuration software, you can configure your access control project offline beforehand (on your laptop). You assign the bell push buttons to the right internal unit. You can set the desired parameters for most devices and units. After, you can quickly and easily upload the entire configuration into the installation, using the PC interface (10-855) which is available separately.
The Niko configuration software for access control can also be used to read an existing installation for maintenance of changing the parameters.
Download the Niko configuration software for access control via https://www.niko.eu/NAC_Configuration_SW.
Product details
Niko Configuration Software for access control
Download the free Niko Configuration Software for access control. You can immediately try out the demo version. If you wish to configure the actual access control installation, you will need a PC interface (10-855) and a personal activation code. This PC interface can be purchased separately.
The Niko configuration software allows you to read and configure a new access control installation online. You can also prepare your configuration offline on your laptop. You assign the bell push buttons to the right internal unit. You can set the desired parameters for most devices and units. After, you can quickly and easily load the entire configuration into the installation using the PC interface.
The Niko configuration software can also be used to read an existing installation for maintenance of changing the parameters.
I already have a PC interface (10-855)
Send an e-mail to support@niko.be with the subject 'Request activation code NAC configuration software'. Make sure that you mention the serial number of your PC interface. You will receive your personal activation code no later than the following working day.
I don't have a PC interface yet (10-855)
You can purchase a PC interface at your wholesaler's. You will find a personal activation code for the Niko configuration software with each new PC interface.
Related products
PC interface for programming and configuration
The PC interface, in combination with the Niko configuration software for access control, is suitable to read or configure a new or existing installation and/or modify the settings of separate devices. The interface is connected to the bus via an intermediate circuit board. The connection to the PC or laptop occurs via USB. The drivers for PC interface can be downloaded via www.niko.eu. The drivers are available for PC or laptop with a Windows operating system. • required PC configuration: minimum Windows 98SE • USB connection: USB 1.1 or USB 2.0 For more information and project support, please contact Niko.
Service set
With this service set, a complete installation can be easily programmed by one single person. All devices can be connected with one another without requiring access to the housing units. The service set can also be used to analyse the installation or to locate an error in the installation. Thanks to the built-in call suppression, all basic functions can be tested and programmed without bothering the residents. The service set is connected to the external unit(s) or the bus using a connection plug.
