Wireless Controls - How do I pair a Zigbee® 3.0 lamp with the Niko Zigbee® battery powered switches?

1. Reset the smart Zigbee® lamp. This is typically done by a power reset cycle - switching on/off the power supply a number of times. This varies across the lamp manufacturer:
   1. EcoDim (A60, ST64, G125): switch on/off power 3x.
   2. Gledopto Pro: switch on/off power 5x.
   3. Ikea Trådfri: turn on the light, switch off/on power 6x.
   4. Innr (E27, E22, E14, GU10): Turn on the light for 5 seconds, Turn off and on 6x.
2. Bring the switch in the close vicinity of the smart lamp (maximum 10 cm separation)
3. Pair the Niko battery powered Zigbee® switch with the Zigbee® lamp by pressing the PROG button for 2 seconds (blue LED turns on), followed by short pressing a switch button 2x. When pairing is succesful the blue LED will be on for 4 seconds, then off.

Notes: 

Ensure that the smart Zigbee®device supports Touchlink. When in doubt, contact the lamp manufacturer.

Make sure that the coin cell battery in the battery powered Zigbee® switch is new or fully charged.

The Niko battery powered Zigbee® switch can pair up to eight Zigbee® devices.

Factory reset the switch if you want to clear previous pairing data: Press the PROG button for 2 seconds (blue LED turns on), followed by pressing the prog button for 10 seconds (blue LED blinks 10x). Reset is done when the blue LED is on for 4 seconds, then off.