RF receiver, potential free, 1 changeover contact, flush mounting

Available in May 2025. This article is still in development. The technical specifications could be subject to change. Currently missing technical documents will be added to this page as soon as they are ready.

This flush-mounted receiver allows switching an electrical device ON and OFF using a wireless Easywave button or a wired button. This receiver has a potential-free changeover relay contact, suitable to control devices such as a doorbell or a dimmer.

It can receive signals from a Niko Easywave hand-held transmitter and/or wireless switch. The receiver can be installed behind a Niko blind plate or push button in the colour of your choice. Please note that the combination with the push button requires a wall mounting box with an installation depth of minimum 50 mm.

Up to 32 transmission codes can be programmed into the receiver. The receiver is equipped with either 1-button operation (ON/OFF, DEAD MAN, TIMER) or 2-button operation (ON/OFF, LOGIC).

RF receiver, potential free, 1 changeover contact, flush mounting

• Radiated power: 6.38 mW
• Modulation: FSK
• Input: 1 external push button
• Output: 1 potential-free relay contact (changeover)
• Power consumption (stand-by): 0.3 W
• Power consumption without load: 0.8 W
• Maximum contact load:

- resistive load cosφ=1: 10 A / 2300 VA (N.O.), 6 A / 1380 VA (N.C.)

- inductive load cosφ=0.8: 3 A / 690 VA (N.O.), 2 A / 460 VA (N.C.)

• Not compatible with Niko Home Control (wireless bridge or wireless smart hub)
• Input voltage: 230 Vac ± 10 %, 50 Hz
• Maximum MCB rating: 10 A (limited by national installation rules)
• Communication protocol: Easywave
• Operating frequency: 0.8683 GHz
• Ambient temperature: -20 – +45 °C
• Protection degree: IP20
• Weight: 31 g
• Wire capacity: – 1 x 2.5 mm² per connection terminal
• Marking: CE