RF receiver for motor control, 230 V, 2 N.O. contacts, flush mounting

This flush-mounted receiver allows opening and closing motor-controlled shutters and blinds using a wireless Easywave button or a wired button. This receiver has two 230V normally open relay contacts, suitable to control a tubular motor.

It can receive signals from a Niko Easywave hand-held transmitter and/or wireless switch. The receiver can be installed behind a Niko blind plate or push button in the colour of your choice. Please note that the combination with the push button requires a wall mounting box with an installation depth of minimum 50 mm.

Up to 32 transmission codes can be programmed into the receiver. The receiver is equipped with either 1-button operation (SEQUENCE), 2-button operation (UP/DOWN) or 3-button operation (UP/STOP/DOWN, optionally with slat adjustment for venetian blinds). The runtime of the motor is by default 90 seconds, but can be set separately for each movement direction.

RF receiver for motor control, 230 V, 2 N.O. contacts, flush mounting

• Radiated power: 6.38 mW
• Modulation: FSK
• Input: 2 external push buttons
• Output: 2 potential-loaded relay contacts (normally open)
• Power consumption (stand-by): 0.4 W
• Power consumption without load: 0.8 W
• Maximum contact load:

- resistive load cosφ=1: 5 A / 1150 VA

- inductive load cosφ=0.8: 1.5 A / 345 VA

• Not compatible with Niko Home Control (wireless bridge or wireless smart hub)
• Input voltage: 230 Vac ± 10 %, 50 Hz
• Maximum MCB rating: 6 A (limited by national installation rules)
• Communication protocol: Easywave
• Operating frequency: 0.8683 GHz
• Ambient temperature: -20 – +45 °C
• Protection degree: IP20
• Weight: 31 g
• Wire capacity: – 1 x 2.5 mm² per connection terminal
• Dimensions (HxWxD): 43 x 42 x 17.5 mm
• Marking: CE