Flat presence or absence detector 360°, 12 m, with 2 potential-free contacts, master, for flush-mounting, with EnOcean®, white

Stand-alone or as master combinable with a maximum of 20 secondary detectors (350-41601). The detector has a very flat design of only 5 mm, so that it can be mounted almost flush with the ceiling. Particularly suitable for the switching of installations with 3 phases where the light circuits need to be distributed to several groups for safety reasons. Integrated EnOcean® receiver enabling the manual switching on and off of the lighting with (optional) EnOcean® buttons. For use in offices, schools, conference rooms… in large and small spaces. The two channels are always controlled simultaneously. Depending on the chosen application:

• the lighting must always be switched on manually using a push button (options: 230 V cabled or wireless with EnOcean® button), and is automatically switched off if there is sufficient daylight or no one is in the room (absence detector).
• the lighting is switched on automatically when movement is registered and in case of insufficient daylight. Also here the lighting is automatically switched off if there is sufficient daylight or no one is in the room (presence detector). Lighting will remain on as long as motion is detected and the measured daylight level is lower than the set value.

When a push button is used, upon leaving the room the user can decide to switch off the light immediately (eco off) instead of waiting for the switch-off delay. The light remains switched off, even if movement is still detected in the room. After the set switch-off delay has elapsed, the detector resumes its normal operation. The switch-off delay, the lux value at which the lighting must switch on and the sensitivity of the detector can easily set with the IR remote control (optional) for fast and easy programming.

Finishing colour: white