This mini presence detector with one channel (360°, 10 A) is suitable for flush mounting in ceilings and is used to switch indoor lighting on and off. Thanks to its compact dimensions and discreet design, the mini detector goes virtually unnoticed in any room. The mini detector is flush-mounted using the spring clips on the device. The mini detector has a circular detection range with a diameter of up to 9.5 m. The device with integrated light sensor can be set up as a presence or as an absence detector. When used as a presence detector, the lighting automatically switches on and off (as soon as the switch-off delay has elapsed). When used as an absence detector, the lighting must always be manually switched on first using an NO push button, after which it will be automatically switched off (as soon as the switch-off delay has elapsed). The device is also equipped with the ‘eco off’ function, which allows the user to switch the lighting off using a connected NO push button without having to wait for the switch-off delay. If the lighting is not switched off manually, it will be switched off automatically once the switch-off delay has elapsed. The device has an IP65 protection degree and conforms to the European EN60669-2-1 standard for EMC and safety. The device has been preprogrammed. In order to enter customised settings, the IR remote control unit must be used. The remote control is not included with the device and must be purchased separately.
Finishing colour: white
Mini presence detector, 360°, 230 V, 9 m, for flush mounting, IP65
(white). The detector has one channel for switching indoor lighting on and off and is suitable for flush mounting in ceilings in small offices, sanitary facilities, garages, storage areas … The mini detector is equipped with an integrated light sensor which switches off the lighting as soon as sufficient daylight is measured in the room. The flush-mounting mini detector (IP65) can be used with the factory settings, or the settings can be adjusted with the IR remote control. When several mini detectors are used, the settings of one mini detector are automatically copied to the other mini detectors by the IR remote control. The detection area can be divided by means of an adjustable cover mask. Factory settings: