This presence or absence detector (360°, slave) is suitable for surface mounting on ceilings and is used to switch indoor lighting on and off but only in combination with the master (350-20078). The detector has a circular detection area with a diameter of up to 24 m that can be adjusted using the cover mask. The device follows the settings of the master. The sensitivity of the slave, though, can be set separately. This motion detector has an IP54 protection degree and complies with the European directives for EMC and safety, EN 60669-2-1. A maximum of ten slaves can be connected per master.
Finishing colour: white.
Presence or absence detector,10 A, PIR 360°, 230 V, 24 m, slave, for surface-mounting. (white). The slave allows the detection area to be greatly increased. The detector can be used with the factory settings, or the settings can be manually adjusted on the device. The detection area can be divided by means of an adjustable cover mask. Factory settings:
The detector has one potentiometer and two DIP switches for manually adjusting the settings: