Mechanism for a double, horizontal socket outlet with pin earthing, screw fixing and shutters. This socket outlet has a flush-mounting depth of 21 mm. A finishing set and flush surround plate in the colour of your choice must be ordered separately.
Base for horizontal, double socket outlet with earth pin and shutters, flush-mounting depth 21 mm, screw terminals. The sockets are fitted with cage clamps with permanent screws. These screws have combination screwheads (Pz2 or slot 1 x 6 mm). Moreover, every screw is provided with a screwdriver slot that prevents the screwdriver from sliding off the screwhead. All connection terminals are located at the top of the end socket and can contain up to 4 x 2.5 mm² of wire. The earthing terminal even up to 2 x 2.5 mm² + 2 x 4 mm². The stripping length (14 mm) of the wires is indelibly imprinted on the back of the base. On the horizontal axis, the grooves each have two screw holes of 7 mm so that the socket outlet can be easily mounted in a flush-mounting box. In this configuration, the screws are on the horizontal axis or in channelling systems with which the double, pre-wired socket outlet must be attached to the mounting brackets. By means of the screw holes, the flush-mounting frame is positioned over the screwheads of the screws of the flush-mounting box or mounting bracket and is then shifted to the desired position and screwed tight. For attachment to flush-mounting boxes where the screws are positioned on the vertical axis, the grooves are on the vertical axis, each one equipped with one screw hole. Thanks to the 7 mm screw holes, the flush-mounting frame is positioned over the screwheads of the screws of the flush-mounting box and is then shifted to the left in order to be attached in the correct position. The flush-mounting frame is made from 1 mm-thick metal which is galvanized on all sides after cutting, even on the cut edges. On the horizontal and vertical axes, the flush-mounting frame has 4 grooves for screw mounting in flush-mounting boxes. These grooves have a screw aperture of 7 mm. For mounting on panels, the flush-mounting frame is equipped with 4 screw holes (indicated by a screw symbol) with a diameter of 3 mm. The middle of the flush-mounting frame is indicated (chalk line, laser, ..) in both the horizontal and vertical directions, so that mounting one or more mechanisms can be carried out quickly and easily. At the right and left sides, the flush-mounting frame is equipped with folded-up dovetails, allowing for a quick and perfect horizontal coupling of several switches. The folded-up edges on the outside of the base and their continuation to the inside ensure additional robustness. The bases can be coupled vertically with a centre-to-centre distance of 60 x 71 mm by sliding them into each other. They automatically lock into place. For horizontal coupling of bases with a centre-to-centre distance of 71 mm, the base is equipped with two pre-formed lips at the bottom. By folding these lips down over a length of 1 mm, this rests perfectly on the one below and the centre-to-centre distance of 71 mm is guaranteed. The 4 rectangular openings (7 x 2.5 mm) in the flush-mounting frame can compensate for a margin of 1 to 1.2 mm if the flush-mounting box protrudes beyond the plasterwork. In the case of such a margin, the flush surround plate can still butt up perfectly against the wall.
- Protection degree: The combination of a mechanism, a central plate and a flush surround plate has a protection degree of IP41
- Flush-mounting depth: 21 mm
- Certification marks: CEBEC, NF
- Marking: CE