Daylight control module for dimming indoor lighting

With this device, you can save substantial energy by making optimal use of natural daylight. This modular lighting control is used to dim indoor lighting in different zones and is used in combination with a photo cell, 1 or more motion detectors and the power supply 360-47000. The device is equipped with three 1-10V outputs for regulating the dimmable electronic control gear (ECG) for fluorescent and compact fluorescent lighting. If there is insufficient daylight and motion is detected, then the lighting is automatically switched on. The lighting is automatically switched back off again when there is sufficient daylight or after the pre-set switch-off delay. Manual control is also possible using a time switch, an N.O. push button or a four-fold push button with feedback LEDs. The lighting control has an IP20 protection degree and complies with the European directives for EMC and safety, EN60669-2-1.

Daylight control module for dimming indoor lighting

Niko modular daylight control for zone-based dimming of indoor lighting. Equipped with three 1-10 V outputs for the regulation of dimmable electronic control gear (EVSA) for fluorescent and compact fluorescent lighting. Use in combination with a Niko photo cell, motion detector(s) and Niko power supply 360-47000 for switching loads. Automatic lighting control dependent on the level of daylight measured and the motion detected. Automatic OFF in sufficient daylight or after switch-off delay. Optional control using time switch, N.O. push button, 4-fold push button with feedback LEDs. Equipped with five pre-programmed applications.

Power supply voltage: 24 Vdc ±10 %.

Outputs 1, 2 and 3: 1-10 V

Max. dimming capacity: 50 mA.

Zones: 1, 2 or 3.

Light range: 3…300 lux, 30 lux…3 Klux, 300 lux…30 Klux, 600 lux…60 Klux.

Switch-off delay: 0…60 min.

Protection degree: IP20.

DIN 4 modules

Dimensions (HxWxD): 90 x 70 x 55 mm.

Operating temperature: 5°C to 50°C.

In compliance with the European directives for EMC and safety EN60669-2-1.

• Märkning: CE