Wireless switch with two buttons

With this wireless switch, you control a maximum of 2 circuits, independent of one another, but dependent on the receiver settings. The switch is used for 1-button and 2-button functions.

Technical characteristics:

• power supply voltage: battery, 3 V DC (supplied);
• transmission range: approximately 30 meters indoors, 100 meters in open spaces;
• mounting: with the adhesive strips or screws provided.
• frequency band: 868,0 – 868,6MHz
• maximum power output: -1,3 dBm

Base for wireless switch with 2 control buttons. Wall-mounted transmitter with 2 connections with RF technology for wireless remote control of Niko RF receivers on the frequency 868.3MHz. Each transmitter can control an unlimited number of receivers. Each receiver can be controlled by a maximum of 32 transmitters. Minimum transmission range in a building: 30m; in open spaces: 100m. Modulation type: FSK. Supplied complete with battery and pre-programmed transmitter address. Buttons and flush surround plates are to be ordered separately. Battery type: Renata 3V/270mAh CR2430; Saft 3V/270mAh LM2430; Varta 3V/260mAh CR2430; Panasonic 3V/250mAh CR2330. Can be either stuck or screwed to the wall or flush-mounting box. In compliance with Belgian and European legislation: CE marking on the device. Complies with the EN60669-2-1 standard, the EC legislation and meets the essential requirements of the R&TTE Directive 1999/5/EC. Can be used in all European Member States. User manual is included.

• Dimensions (HxWxD): 71 x 103 mm
• Marking: CE

Base with claw fixing for the mounting of a wireless switch on a flush-mounting box. This base makes it possible to install a wireless switch on a flush-mounting box. You can

click it together and combine it with one or more flush-mounting mechanisms from Niko.

Base with screw fixing for the mounting of a wireless switch on a flush-mounting box. This base makes it possible to install a wireless switch on a flush-mounting box. You can

click it together and combine it with one or more flush-mounting mechanisms from Niko.

Single key for wireless switch or bus push button. Finishing colour: cream.

Single key with the symbol 'I' and '0' for wireless switch or bus push button. Finishing colour: cream.

A single key with the symbol 'up' and 'down' for a bus push button. Finishing colour: alu steel grey coated.

A single switch with space for the addition of your own text for a bus push button. Finishing colour: alu steel grey coated.

This set of claws is used to attach wall-mounted circuit boards to standard flush-mounting boxes without the use of screws.

This set of claws is used to attach wall-mounted circuit boards to standard flush-mounting boxes without the use of screws.