Home Products Light and light control Dimming Rotary dimmer 500 VA, 2 wire

Rotary dimmer 500 VA, 2 wire

Product details

This product consists of several components. Below you will find an overview of all the component parts.
  • Available until 30/06/2019 and afterwards until the end of stock.

    Base for rotary dimmer, 500 VA, 2 wire

    Add to 'My favorites' Remove from 'My favorites'
    310-01601

    Description

    Base for a rotary dimmer with a capacity of 500 VA. A finishing set XXX-31000 and flush surround plate in the colour of your choice must be ordered separately.

    Specification description

    Base for rotary dimmer, 500 VA, 2 wire. Flush-mounting dimmer with control via rotary button for inductive loads. Activate by pressing on the button and adjust by rotating the knob. The degree of interference suppression complies with the European standard EN 55015 and with the international standard CISPR15. The dimmer can replace single-pole switches and two-way switches.

    The sockets are equipped with screw terminals for clamping the wires. When fixing in a flush-mounting box screws should be used. The flush-mounting frame is made from 1 mm-thick metal which is galvanized on all sides after cutting, even on the cut edges. On the horizontal and vertical axes, the flush-mounting frame has 4 grooves for screw mounting in flush-mounting boxes. These grooves have a screw aperture of 7 mm. For mounting on panels, the flush-mounting frame is equipped with 4 screw holes (indicated by a screw symbol) with a diameter of 3 mm. The middle of the flush-mounting frame is indicated (chalk line, laser, ..) in both the horizontal and vertical directions, so that mounting one or more mechanisms can be carried out quickly and easily. At the right and left sides, the flush-mounting frame is equipped with folded-up dovetails, allowing for a quick and perfect horizontal coupling of several switches. The folded-up edges on the outside of the base and their continuation to the inside ensure additional robustness. The bases can be coupled vertically with a centre-to-centre distance of 60 x 71 mm by sliding them into each other. They automatically lock into place. For horizontal coupling of bases with a centre-to-centre distance of 71 mm, the base is equipped with two pre-formed lips at the bottom. By folding these lips down over a length of 1 mm, this rests perfectly on the one below and the centre-to-centre distance of 71 mm is guaranteed. The 4 rectangular openings (7 x 2.5 mm) in the flush-mounting frame can compensate for a margin of 1 to 1.2 mm if the flush-mounting box protrudes beyond the plasterwork. In the case of such a margin, the flush surround plate can still butt up perfectly against the wall.

    • Wire capacity: 2 x 1.5 mm² or 1 x 2.5 mm² per connection terminal
    • Input voltage: 230 Vac ± 10 %, 50 Hz
    • Minimum load: 50 VA
    • Maximum load 230V-halogen lamps: 400 W
    • Maximum load ferromagnetic transformer: 500 VA
    • Maximum load bulb: 500 W
    • Maximum load toroidal core transformer: 200 VA
    • Hum-free: yes
    • Protection from overload: thermal overload protection with automatic reset function
    • Short circuit proof: short circuit protection via fuse Built-in spare fuse.
    • Capacity reduction: at an ambient temperature above 20°C the maximum load will decrease by 5 % per 5 °C
    • Connection terminals: 3 connection terminals
    • Flush-mounting depth: 31.5 mm
    • Marking: CE

Accessories

list 0
Favorites