Which wiring is recommended for Niko Home Control?
A two-wire bus cable provides power to the various control elements outside the electrical cabinet. The wiring diagram has a free topology, which means you are not bound by a fixed cabling diagram. All controls are easily and quickly connected thanks to the non-polarised bus cabling. Simply connect the two wires in the terminals with no risk of a faulty connection.
The distance between the power supply and the furthest point in the installation depends on the cross-sectional area of the bus cable:
The touchscreen is connected via a UTP cable and a power supply cable or a single UTP cable in combination with a Power over Ethernet module (550-00501) in the electrical cabinet.
Inside the electrical cabinet, modules located on one and the same DIN rail are interconnected via a sliding contact. A rail coupler, or a second power supply if needed, should be used first on every new DIN rail. Connect all four connection terminals (+, -, B1, B2) to the corresponding connection terminals of the rail coupler or the power supply on the previous and next rails. Polarisation is important in this case.