|
|
Description
The universal modular dimmer plus, 5-350 W, is intended for DIN-rail mounting, is 1 U wide and is operated using a push button. The device is suitable for dimming all dimmable lamps (in other words, resistive, inductive and capacitive loads, dimmable LEDs and economy lamps (CFLi). It cannot be used for the control of motors. The minimum load is 5 W and the module can handle loads up to 350 W. The maximum load for LED and economy lamps is 200 W.
The dimmer functions both as a phase control dimmer and as a reverse phase control dimmer.
Documents
Specification description
This 1 U universal modular dimmer, 5-350 W, is intended for DIN-rail mounting, is 1 U wide and is operated using a push button. The device is suitable for dimming all dimmable lamps (in other words, resistive, inductive and capacitive loads, dimmable LEDs and economy lamps (CFLi). It cannot be used for the control of motors. The minimum load is 5 W and the module can handle loads up to 350 W. The maximum load for LED and economy lamps is 200 W.
The dimmer functions both as a phase control dimmer and as a reverse phase control dimmer. The choice of lamp type occurs via settings on the module. In addition, the lamp-specific minimum dimming level can also be adjusted. The dimmer is equipped with automatic detection and indication of faulty conditions (overload, short circuit, ...).
The control occurs via N.O. push buttons (non-illuminated) or potential-free push buttons (8-24 V). Press briefly to switch on and off. Hold down to dim up and down. When holding down, the dimming direction is switched after each interruption (dimming up -> stop -> dimming down-> stop -> dimming up -> etc.). Once the maximum intensity has been reached, the dimming level remains unchanged. The last dimming level reached before the dimmer is switched off is saved in a memory. Up to 30 N.O. contacts (170-0000X) can be connected in parallel (max. distance 100 m). The push buttons are not galvanically isolated.
There is also the option of 2 additional modes. The selection of a specific mode occurs using DIP switches on the device.
Mode 1: Single-button control (normal operation)
By selecting this mode, the dimmer works with push-button control (N.O. or potential-free).
Mode 2: Staircase function
By selecting this mode, the lighting switches off automatically after 3’.
The dimmer can be used with or without memory. The standard setting of the dimmer is without memory function. You use the control button to change this function.
In addition, the dimmer can also function in "all-off" mode. If another control point is connected to the all-off input, then this control can switch off all lighting that is connected to this dimmer.
|